Xblue Networks X-2020 - Manual (Page 23)

XBLUE Networks 23
Setup
Get
ting Started
2
Use the following steps to program a X2020 that is going to be used remotely (WAN):
•
Step 1 - Press the menu soft button
•
Step 2 - Use the down navigation key to locate “16. Admin”
•
Step 3 - Press the center navigation key and then enter the Admin Password (default is 1234)
•
Step 4 - Press the center navigation key and then use the down navigation key to locate “7. SIP”
•
Step 5 - Locate “1. SIP Server” and press the center navigation key
•
Step 6 - Locate the “SIP Proxy” and press the center navigation key. Press back space (Backsp) to delete
the existing number and enter the IP Address of the X-25 and then press the center navigation key.
•
Step 7 - Use the down navigation key to locate “Outbound Proxy” and then press the center navigation
key. Press the back space (Backsp) to delete the existing number and enter the IP Address of the X-25
and then press the center navigation key.
•
Step 8 - Use the down navigation key to locate “Registrar Server” and then press the center navigation
key. Press the back space (Backsp) to delete the existing number and enter the IP Address of the X-25
and then press the center navigation key.
•
Step 9 - Use the down navigation key to locate “Registrar Outbound” and then press the center naviga-
tion key. Press the back space (Backsp) to delete the existing number and enter the IP Address of the X-
25 and then press the center navigation key.
•
Step 10 - Press the left navigation key once and use the down navigation key to locate “4. Authenti-
cation”
•
Step 11 - Press the center navigation key. There are two options Authorized ID and Authorized Password
•
Step 12 - Select “Authorized ID” to enter the new extension number. This extension number must be pre-
programmed into the X-25 system.
•
Step 13 - Select “Authorized Password” to enter the password for the entered extension number.
•
Step 14 - Press the left navigation key until it asks “Do you want to quit?” Press the center navigation
key, and select “Yes”. The telephone will reboot, and connect to the X-25 gateway.