Xblue Networks X-2020 - Manual (Page 12)

Introduction
12 XBLUE Networks
1
Pa
ckage Contents
TABLE 1.1
No. Part Nam e Desc rip tion
1 Handset Top Cradle For placement of the Handset
2 Hook Switch For hanging up your handset
3 Cradle Latch Used to Secure the handset to the base unit
4 Speaker Speaker output for handsfree operation
5 Handset Bottom Cradle for the bottom of the handset
6 Handset Cord Port Used to connect the handset to the telephone base
7 Headset Wire Port Used to connect an ancillary headset to the telephone base
8 Message LED Light Bar Flashes for a new call and when there is a new Voice Mail Message
9 Graphic LCD LCD display showing date, time, phone number, Caller ID, line status etc.
10
Soft Keys
Soft keys change as the phone is being used, which will assist you with
the most used features
11 EMD (DSS Sidecar) A special module that connects an additional 24 programmable buttons
12
Navigation OK or Select Key
The center “Check” button of the “Cell-Phone-Like” navigation keys, is
used to “select” or to select “OK”
13
Navigator Control Keys
Navigation, left, down, up and right are used to
navigate through menu programming and during the normal
operation.
14
Programmable buttons - such
as line keys
These keys are customizable allowing you to activate a feature with a
single button press. These buttons can be programmed as a direct access
to a telephone line, extension, DND, Speed dial, Call Park, Live Record, or
a direct dial number.
15
Speaker Button
Press the speaker button to answer a ringing call. The button will turn
green when the speakerphone is active.
16
Mute Button
Press the Mute button to suspend the transmission of your voice to speak
privately with someone in your office. When the Button is red it is active
and not transmitting, when the LED is out it will transmit your voice.
17
Headset Button
Once an ancillary headset is connected to the phone, press the Headset
button to activate, and the speakerphone to answer the call.