Xblue Networks X-2020 - Manual (Page 22)

Setup
22 XBLUE Networks
2
Get
ting Started
Getting Started
At default, the X2020 is programmed as DHCP. Therefore, when it located on the same LAN as the X-25, it will
automatically authenticate and be assigned an extension number. The extension number can be reassigned to
accommodate specific numbering plans using either the telephone or a standard windows Internet browser such
as Windows Internet Explorer.
Programming with the X2020 telephone
Use the following steps to change an extension’s telephone number when it is connected to the LAN:
•
Step 1 - Press the menu soft button
•
Step 2 - Use the down navigation key to locate “16. Admin”
•
Step 3 - Press the center navigation key and then enter the Admin Password (default is 1234)
•
Step 4 - Press the center navigation key and then use the down navigation key to locate “7. SIP”
•
Step 5 - Use the down navigation key to locate “4. Authentication”
•
Step 6 - Press the center navigation key. There are two options Authorized ID and Authorized Password
•
Step 7 - Select “Authorized ID” to enter the new extension number. This extension number must be pre-
programmed into the X-25 system.
•
Step 8 - Select “Authorized Password” to enter the password for the entered extension number.