StorCase Technology InfoStation 12-Bay 4U Ultra160/SATA - Manual (Page 30)

InfoStation 12-bay RAID User's Guide - Rev. C00 StorCase Technology, Inc.
RAID Controller Configuration 19
Configuring the RAID Controller
There are two aspects to configuring the RAID controller:
• Configuration of the RAID system and communication parameters
• Setting up and configuration of arrays within the RAID system
Users are advised to configure the system first, then the arrays.
Initial RAID Configuration
This section provides instructions on how to set-up a RAID configuration for the first time.
These steps may also be performed by the Monitor Utility. Refer to section "Monitor Utility"
for information on configuring and using this feature.
0 Quick Set-Up
1. Make sure the RAID Controller is ON.
2. Press Enter to display the Configuration Mode. Enter in the Password (default
password is 00000000) when prompted.
3. Press Enter to open the 0 Quick Set-Up menu.
4. Scroll through the list of RAID levels until the desired RAID level is displayed, then
press Enter.