SpectraCal TVLogic XVM and LEM Series Monitors User Manual
Page 6
17544 Midvale Ave. N. Shoreline, WA 98133 USA
Corporate: +1 206 420 7514 | Tech Support: +1 206 457 8949 |
Option B - Software LUT File
CalMAN 3D LUT Monitor Calibration
Follow this procedure to create an optimized software 3D LUT calibration file, ready to be loaded into
a TVLogic XVM / LEM series monitor.
TVLogic Display Presets
Before connecting CalMAN to a TVLogic monitor for 3D LUT calibration, preset the following controls
in the TVLogic Color menu.
Color / Color Temp: Select your desired Color Temp preset. Do not use a Custom Color Temp
preset to adjust the monitor’s Gain and Bias controls.
Color / Color Space: Select the User Color Space to write to the User 3D LUT. If you select one
of the other Color Space modes, you will overwrite the factory 3D LUT for that mode.
Color Cube (3D LUT) Workflow
The Color Cube workflow in CalMAN is used to create monitor calibration 3D cube LUTs. In the
CalMAN main menu, select Open Workflow Template / Color Cube (3D LUT). Proceed through each
step of the Color Cube workflow in a normal fashion, using the following notes for TVLogic monitor
specifics.
1. On the Session Setup page, under Find 3D LUT Device, select "SpectraCal - Cube Generator
(3D LUT).”
2. Skip the 1D Ramp LUT page (a 1D LUT does not need to be created).
3. On the 3D Cube LUT page, click the AutoCal action button in the lower right.
4. On the popup AutoCal Setup dialog (shown below), under File Format, select “TVLogic –
XVM/LEM series (.lut)” (creates a 17x17x17 10-bit 3D LUT format file).