Nor-Cal Intellisys Adaptive Pressure Controllers - Manual (Page 3)

3 Call toll free 800-824-4166 or 530-842-4457 • FAX 530-842-9130
I
ntellIsys
A
dAptIve
p
ressure
C
ontrollers
APC-OP-LIT 1/12
Contact Nor-Cal Products
Intellisys Customer Support
at 800-824-4166 ext. 186
or visit our website
at www.n-c.com
List of Figures
4.1 ...... Typical installation and configuration of a buried box
Intellisys Downstream Pressure Control system .............14
4.2 ...... Typical installation and configuration of an
IQ Pressure Control valve ...............................................14
8.1 ...... IQD DeviceNet connector pin assignment .....................22
8.2 ...... DeviceNet baud rate selection switch ............................22
8.3 ...... DeviceNet address switches ..........................................22
8.4 ...... Typical DeviceNet Hardware Installation ........................23
9.1 ...... Object Model for the Process Control Valve Device ........26
9.2 ...... Object State Transition Diagram ....................................29
10.1 .... LCD Front Panel Interface ..............................................33
10.2 .... Configure Setpoints ......................................................36
10.3 .... Utility Menu ..................................................................38
12.1 .... Possible Failure Modes and Recommended Actions.......42
12.2 .... Valid Status LED Combinations .....................................43
List of Tables
2.1 ...... APC Controller General Equipment Specifications ...........5
2.2 ..... APC Controller Analog TTL I/O ........................................5
2.3 ...... APC Controller RS-232 Serial I/O .....................................5
2.4 ...... APC Controller Performance ...........................................5
2.5 ...... APC Controller Reliability ................................................5
3.1.1 ... (J3&J4) “APC-X50-A” Gauge Connector ........................7
3.1.2 ... (J1) “APC-X50-A” A/C Power Connector ........................7
3.1.3 ... (J5) “APC-X50-A” Valve Connector ................................7
3.1.4 .. (J2) “APC-X50-A” RS-232 Serial Port ..............................7
3.1.5 ... (SW1) “APC-X50-A” Dip Switch Settings for
Serial Communications ...................................................7
3.1.6 ... (J6) “APC-X50-A” Analog / TTL Connector .....................7
3.2.1 ... (J3&J4) “APC-X00-A” Gauge Connector ........................8
3.2.2 ... (J1) “APC-X00-A” A/C Power Connector ........................8
3.2.3 ... (J5) “APC-X00-A” Valve Connector ................................8
3.2.4 .. (J2) “APC-X00-A” RS-232 Serial Port ..............................8
3.2.5 .. (SW1) “APC-X00-A” Dip Switch Settings for
Serial Communications ...................................................8
3.2.6 .. (J6) “APC-X00-A” Analog / TTL Connector .....................8
3.3.1 ... (J1) “APC-800L-A-S01” Gauge Connector .....................9
3.3.2 ... (J2) “APC-800L-A-S01” Power Connector ......................9
3.3.3 ... (J3) “APC-800L-A-S01” Valve Connector ........................9
3.3.4 ... (J4) “APC-800L-A-S01” I/O Connector...........................9
3.4.1 ... (J4) “APC-X00L-A” Analog / TTL Connector ..................10
3.4.2 ... (SW1) “APC-X00L-A” Dip Switches ..............................10
3.4.3 ... (J1) “APC-X00L-A” Valve Connector .............................10
3.4.4 ... (J3) “APC-X00L-A” Auxiliary Connector .......................10
3.4.5 ... (J2) “APC-X00L-A” Gauge Connector ..........................10
3.5.1 ... (J1) “APC-X00L-D” DeviceNet Network Connector.......11
3.5.2 ... (J2) “APC-X00L-D” Auxiliary Connector .......................11
3.5.3 ... (J3) “APC-X00L-D” Gauge Connector ..........................11
3.5.4 ... (J3) “APC-X00L-D” Valve Connector .............................11
3.6.1 ... (SW1) “IQA” Dip Switches ............................................12
3.6.2 ... (J3) “IQA” Auxiliary Connector .....................................12
3.6.3 ... (J2) “IQA” Gauge Connector ........................................12
3.6.4 ... (J4) “IQA” Analog / TTL Connector ...............................12
3.7.1 ... (J1) “IQD” DeviceNet Network Connector ....................13
3.7.2 ... (J2) “IQD” Auxiliary Connector .....................................13
3.7.3 ... (J3) “IQD” Gauge Connector ........................................13
6.1 ...... RS-232 Serial Commands .............................................16
6.2 ...... RS-232 Serial Requests and Responses ..........................16
6.3 ...... Values for xx for use with Dual Range Mode ..................18
8.1 ...... DeviceNet Module LED Status .......................................22
8.2 ...... DeviceNet Network LED Status ......................................22
8.3 ...... DeviceNet Explicit Messaging ........................................24
8.4 ...... Output Assembly Formats .............................................25
8.5 ...... Input Assembly Formats ................................................25
9.1.1 ... Identity Object Attributes ..............................................27
9.1.2 ... Nor-Cal Product Types ...................................................27 9.3.1 ... DeviceNet Object Attributes ..........................................27
9.4.1 ... Assembly Object Attributes ...........................................28
9.5.1 ... Input Assembly Instances ..............................................28
9.5.2 ... Output Assembly Instances ...........................................28
9.6.1 ... Connection Object Attributes .......................................28
9.7.1 ... Discrete Input Point Object Attribute; Instance ID 1........28
9.7.2 ... Discrete Input Point Object Attribute; Instance ID 2........28
9.8.1 ... S-Device Supervisor Object Attributes ...........................29
9.8.2 ... S-Device Supervisor Object Exception Status Bit Map.....29
9.8.3 ... Device Status Attribute Value ........................................29
9.9.1 ... S-Analog Sensor Instances ............................................30
9.9.2 ... S-Analog Sensor Object Attributes ................................30
9.10.1 . S-Analog Actuator Object Attributes .............................31
9.10.2 . S-Analog Actuator Exception Status Bitmap ..................31
9.11.1 . S-Single Stage Controller Object Attributes ...................31
9.11.2 . S-Single Stage Controller Object Subclass Attributes;
Instance 1 .....................................................................31
9.12.1 . Selection Object Attributes; Instance 1 ..........................32
9.12.2 . Selection Object Attributes; Instance 2 ..........................32
Information in this manual is subject to change without notice.