LINK Systems LinkNet II - Manual (Page 77)

6.13 Part Reports - Trend
Part trend reports show the history of certain statistics over time. For each run of a part, the OEE,
uptime percentage, setup time, average utilization, production utilization, production time percentage,
and average total tons are collected. The trend of these measurements versus runs can be shown in these
reports. To run a part trend report, select “Part”, “Trend”, and the statistic to trend from the “Reports”
menu. Dialog boxes will appear asking for the time, machines, and parts for which to run the report (see
section 6.1 for details on these dialogs).
The trend report itself consists of two sections - details and a graph. The details section shows each
run the part was used, the machine and job number it was run under, the date the run was started and
closed, and the numeric values for the statistic selected. The graph shows the numeric values by run in a
bar chart.
6.14 Preventive
Maintenance Reports – Tripped Items
Preventive maintenance items (see section 4.15 for information on configuring preventive
maintenance items) are “tripped” after the number of strokes, time, etc. have passed the limit set for
them. This report shows all items that have come due for servicing. To run a preventive maintenance
tripped items report, select “Preventive Maintenance”, “Tripped Items”, and then “By Machine” or “By
Tool” from the “Reports” menu. The “By Machine” selection will display all machine items that are
due for service. Likewise, the “By Tool” selection will display all tooling items that are due for service.
6.15 Preventive Maintenance Reports – All Items
This report is similar to the “Tripped Items” report in the previous section except that all
maintenance will be displayed regardless of whether they are due for servicing or not. To run a
preventive maintenance tripped items report, select “Preventive Maintenance”, “All Items”, and then
“By Machine” or “By Tool” from the “Reports” menu.
Manual Version 1.1 10/28/2001 6.9