LINK Systems LinkNet II - Manual (Page 50)

4.12.1.1 Part General Settings
The “General” part settings page (see Figure 4.31) has the following settings:
Internal Part Number: The internal part number can be up to 50 alphanumeric characters.
Description: The part description will show up in part lists and reports.
Internal Material Number: Set this to the material typically used to make this part.
Customer Name: The name of the customer for whom this part is made.
Customer Part Number: The customers part number for this part (50 alphanumeric characters).
4.12.1.2 Part Physical Characteristics Settings
The “Physical
Characteristics” settings page
(see Figure 4.32) contains
information about the physical
nature of the part. The settings
in this page are not currently
used by LinkNet, but may be in
the future. At present, these are
for informational purposes. The
information and settings on this
page are:
Figure 4.32: Part Configuration Physical Characteristics Settings
Show Units In: All units on this
page can be shown in English or
metric units. Note that values
can be entered in one unit, and
displayed in another.
Weight of 1 Part: The weight of
one of this part.
4.12.1.3 Part Miscellaneous Settings
The “Miscellaneous” settings page contains customer fields for the part. LinkNet does not directly
use the customer fields. These three fields are provided for custom uses by, of course, the customer.
4.12.1.4 Part
Notes
The “Notes” settings page provides a space for part notes.
Manual Version 1.1 10/28/2001 4.28