Adding a job – LINK Systems LinkNet II User Manual
Page 53

4.13.1 Adding a Job
Adding a job is a little
different from adding most of
the other items in LinkNet,
such as parts or material, in
that the machine for the job
must first be specified.
Figure 4.34: Job Configuration Machine Selection
To add a job, hit the “Add
Job” button at the bottom of
the job listing as shown in
Figure 4.33. A machine
listing similar to Figure 4.34
should appear. Select the
machine from the list that the
job should be added to and hit
the “Select” button at the
bottom of the listing or
“double click” the machine in
the list. A dialog box similar
to Figure 4.35 should appear.
Note that this dialog box has
“tabs” along the top showing
“General”, “Physical
Characteristics”, “Tooling”,
“Miscellaneous”, and “Notes”.
Each of these tabs, when hit, will
bring up a different page of
options for the part. The
following sections detail each
page of settings.
Figure 4.35: Job Configuration General Settings Dialog Box
Manual Version 1.1
10/28/2001
4.31