Denon AVR-3806 - Manual (Page 76)

71
Advanced Setup – Part 1 Advanced Setup – Part 1
3 Press the CURSOR F F or G G button to select the
speaker to be set.
• The screen switches to the character input screen.
Example: When “L/R CH” is selected.
5
Press the ENTER button to enter the setting.
• The “Manual EQ” screen reappears.
6 Press the CURSOR D D or H H button to select the
“Exit”, then press the ENTER button.
• The “Advanced Playback” menu reappears.
The display changes as follows.
When the surround back speaker setting is set to
“1spkr” at “Speaker Configuration”, this is set to
“SB”.
e Select the “All CH”
In this case, speaker selection is not performed.
If a value is already set for the FL channel, the data
stored for the FL channel is displayed.
q Select the “L/R CH”
w Select the “Each CH”
FL/FR
SBL/SBR
C SLA/SRA
SLB/SRB SL/SR A+B
FL
SBR
1spkr
FR C SLA SRA SLB
SRB SBL SR A+B SL A+B
SB
4 Press the CURSOR D D or H H button to select the
frequency, then press the CURSOR F F or G G
button to adjust the gain level.
Each frequency can be adjusted the range from –20 dB to
+6 dB in 0.5 dB step.
7 Press the CURSOR D D or H H button to select the
“Exit”, then press the ENTER button.
• The “System Setup Menu” reappears.
• “Base Curve Copy” is displayed after performing the Auto
Setup.
• To restore the settings to their defaults, select “Default Yes
0 ”, then press the CURSOR F F button.
• If the “Auto Setup” procedure has not been performed, this
item is not displayed.
Procedure for copying the “Flat” correction
curve
1 Press the CURSOR D D button to select the “Base
Curve Copy”, then press the CURSOR F F button.
2 Press the CURSOR F F button to select the “Yes”.
The type of the copied correction curve is displayed in the
upper right of this screen.
3
Press the ENTER button to enter the setting.
• The “Manual EQ” screen reappears.