Denon AVR-3806 User Manual
Page 46
41
Basic Operation
Basic Operation
2
Surround parameters r
EFFECT:
This parameter turns the effect signals with multi surround
mode speaker effects on and off in the WIDE SCREEN mode.
When this parameter is turned off, the SBL and SBR channel
signals are equivalent to the SL and SR channels, respectively.
LEVEL:
This parameter sets the strength of the effect signals in the
WIDE SCREEN mode. It can be set in 15 steps, from “1” to
“15”. Set this to a low level if the positioning or phase of the
surround signals sounds unnatural.
ROOM SIZE:
This sets the size of the sound field.
There are five settings: “small”, “med.s” (medium-small),
“medium”, “med.l” (medium-large) and “large”. “small”
recreates a small sound field, “large” a large sound field.
SB CH OUT
• ON:
Playback is conducted using the surround back speaker.
• OFF:
Playback is conducted without using the surround back
speaker.
NOTE:
This operation can be performed directly pressing the
SURROUND BACK button on the main unit’s panel.
EFFECT LEVEL:
This sets the strength of the surround effect.
The level can be set in 15 steps from 1 to 15. Lower the level
if the sound seems distorted.
DELAY TIME:
The delay time can be set within the range of 0 to 300 ms only
in the matrix mode.
Subwoofer ON/OFF:
The subwoofer output can be controlled directly.
SW ATT:
This is the parameter for reducing the level of the subwoofer
channel when playing in the EXT. IN input mode. Depending on
the player you are using, the subwoofer channel’s playback
level may seem too high. If so, set “SW ATT” to “ON”.
For DENON players, use with the default settings (“OFF”).
CURSOR
SURROUND
PARAMETER
ENTER
TONE DEFEAT
Tone control setting
• Use the tone control setting to adjust the bass and treble as
desired.
• The tone control function will not work in the PURE DIRECT or
DIRECT mode.
1
Press the
SURROUND PARAMETER
button.
• The surround parameter menu is displayed.
2
Press the
CURSOR D
D
or
H
H
button to select the
“TONE”.
2
Adjusting the tone
The screen selected surround mode appears.
3
Press the
CURSOR F
F
button.
• Switch to the “Tone Control” screen.
The screen selected surround mode appears.
ENTER
CURSOR
SURROUND
PARAMETER