Step 9 – test mode – Datalogic Scanning Matrix 400 User Manual

Page 28

Text mode
Original mode

MATRIX 400™ REFERENCE MANUAL

STEP 9 – TEST MODE

Use a code suitable to your application to test the reading performance of the system.

1. Enter the Test function by pressing and holding the X-PRESS™ push button until the

Test LED is on.

2. Release the button to enter the Test function.

Once entered, the Bar Graph on the five LEDs is activated and if the reader starts
reading codes the Bar-Graph shows the Good Read Rate. In case of no read condition,
only the STATUS LED is on and blinks.

READY

green

yellow

red

SETUP

FOCUS

TEST

LEARN

GOOD

TRIGGER

COM

STATUS

Figure 17 – X-PRESS™ Interface: Test Function

3. To exit the Test, press the X-PRESS™ push button once.

NOTE

By default, the Test exits automatically after three minutes.

The Bar Graph has the following meaning:

READY

 95%

 75%

 60%

 40%

 20%