Fixed altitude & heading lock mode instruction, 6 fixed altitude & heading lock mode instruction – FeiYu Tech FY-41AP User Manual
Page 34

Guilin Feiyu Electronic Technology Co., Ltd.
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyu-tech.com [email protected]
Page 32
Failsafe remote control receiver when no signal is received, output a default set
of rudder.
Various models of remote control set runaway protection have said, the
reference to the remote control manual.
Return channel CH6 need to set connected to SW2 is out of control out of control
protection switch to the status of the return. Aileron, elevator, rudder channel is set to
loose rod status, throttle setting have two situation
(1) FY-41AP upgrade to the firmware V1.20 or above version. If connect the
airspeed sensor to the FY-41AP controller,
the throttle don‘t need setting ,the controller will
output a proper controlled quantity according to the target speed .
(2) FY-41AP upgrade to the firmware V1.20 or above version , If you are not use the
airspeed sensor ,the throttle need to set to cruise throttle position.
If debugging balanced mode, the following Futaba remote control T10CHG example
set runaway protection.
Settings, turn off the power to the aircraft, to avoid setting
the motor starts.
First enter the remote control setup menu to find the set of "F / S"; into the F / S menu,
the lever into the neutral position, rudder trimming to maintain the status adjusted, the
throttle lever to the cruise throttle position(apply to situation (2)), the CH6 cut to return
mode. Then in all open channel F/ S, and often set by the "PUSH" button, set successfully
as shown.
After setting the aircraft is powered off control check has successfully entered the
return mode.
Pay attention to safety, to prevent the Failsafe motor rotation, met
items cause damage.
10.6 Fixed altitude & Heading lock Mode instruction
Fixed altitude & Heading lock Mode
– This mode maintains aircraft flight course &
holds the altitude on activation. By using GPS data, the system automatically corrects
flight course deviation & maintains straight-line flight.
Attention: Please make sure the RC stick is released when you switch into
Fixed altitude & Heading lock Mode.
The FY-41AP can record current RC stick
position and lock the flight course and altitude when your RC stick released.