FeiYu Tech FY-41AP - Manual (Page 23)

Guilin Feiyu Electronic Technology Co., Ltd.
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyu-tech.com [email protected]
Page 21
Method two: Setting FY-41AP via “FYGCS 5.11 for FY41AP and Dos”
software
Step three: The remote control switch setting & checking
and setting the direction of the rudder surface automatically
control .
FY-41AP requires a minimum of 6-channel RC receiver.
1) First, the remote control is set to fixed-wing aircraft of conventional layout mode,
do not set any mixing. The rudder angle of the remote control is set to 100%, and
fine-tune gyrus.
2) Need two three-stage switch or rotary switch settings for CH5, CH6 used to
connect SW1 and SW2. Used to switch the flight mode.
3) Connection is completed, the call CH5, CH6 check the settings are correct
control mode, the status of the lights, or OSD display mode to confirm.
4) To switch to manual mode, check the control surfaces of the joystick remote
control aircraft direction is correct, if not correctly adjusted positive on the remote
control rudder control to correct the reverse.
5) Switch to the "Auto Balance Mode" mode, check the control direction according
to the following steps carefully.