FeiYu Tech FY-41AP - Manual (Page 33)

Guilin Feiyu Electronic Technology Co., Ltd.
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyu-tech.com [email protected]
Page 31
The default RC Max Distance Setting programmed into the FY41AP is 4000 meters.
If you upgrade to the firmware V1.16 or above version,you need to adjust this
parameter via “FYGCS5.11 for FY41AP and Dos” software. After FY-41AP connect to
the GCS software successfully ,you can select “Menu->Autopilot Setting->RC
Setting ” to finish the RC Max Distance Setting.
10.3 Circling Radius Setting
The FY41AP can fly over a set GPS point upon activation of Auto Circling Mode via
switch SW-2.
The default circling radius is 80 meters. You may adjust this circling radius using this
Setting Software function. Press ‗Set‘ to confirm and save your updated circling radius.
10.4 The altitude of Return To Launch instructions
When activated in this mode, if the current altitude is greater than 50meters, the
FY-41AP will automatically fly the plane back to the home point.Then after the aircraft
back to the target point, if the altitude greater than 100 meters , the plane will down to
100 meters while circling .For the FY-41AP,there is 50 meters protection altitude for return
home .If the current altitude below 50 meters when activate into RTL, the aircraft will climb
to 50 meters to return.
10.5 FAIL-SAFE setting
The RC receiver remote control mode uncontrolled return of function, you need to
use with runaway protection function remote and the receiver.