Datacom Systems J Class - Manual (Page 232)

D-15
only card in the system and be physically located
in slot 0.
The monitor command lets you change your workstation’s graphics
configuration before you replace your monitor. For information about
changing the configuration after you replace your monitor, go to the
section “Changing Your Monitor Type” in Appendix B of this book.
Displaying the Current Monitor Configuration
To display the current monitor configuration for your system from the
Configuration Menu of the boot console interface, follow the direc-
tions in “Accessing the Boot Console Interface” earlier in this appen-
dix. Once you are in the Boot Console Interface Main Menu, type:
Main Menu: Enter a command or a menu > configuration Enter
This places you in the Configuration Menu. From here type:
Configuration Menu: Enter command > monitor Enter
The screen displays a list of the current monitors configured for your
workstation.
MONITOR INFORMATION
Slot # HPA State Resolution Frequency Class
––––––––– –––––––––– ––––––– –––––––––– ––––––––– –––––––
graphics0 f8000000 Present 1280x1024 72Hz
graphics1 f4000000 Present Fixed
graphics2 f6000000 Empty
graphics3 fa000000 Present 1280x1024 72Hz
Current Console Path: core.RS232_.9600.8.none
Stable Store Console Path: GRAPHICS0
In this example, the graphics cards are configured as follows:
•
Graphics slot 0 Dual Color Graphics Card
•
Graphics slot 1 CRX48Z
•
Graphics slot 2 Empty
•
Graphics slot 3 Second head on dual card in slot 0