Datacom Systems J Class - Manual (Page 175)

B-47
•
Processors are shipped with a dust cover (A) over the connector.
•
There are two connectors on the CPU board for processors. If one
of these connectors is not being used, it will have a dust cover (B)
over the connector.
To remove these dust covers, follow the steps in Figure A–28.
A
B
To remove the dust cover on the proĆ
cessor module, grasp the cover and
pull the cover evenly.
To remove the dust cover on the CPU
board, grasp the tab on the right side
of the cover and gently rock the covĆ
er back and forth while pulling it
gently up.
Install the processor module into the
connector by lining it up over the
connector and pressing firmly and
evenly.