Datacom Systems J Class - Manual (Page 229)

D-12
To reset your workstation, follow the directions in “Accessing the
Boot Console Interface” earlier in this appendix, and then type the
following at the prompt:
Main Menu: Enter a command or a menu > reset Enter
A path is the hardware address of a device that is attached to the I/O
system of your workstation. The path command sets the system paths
shown in Table D–1:
Table D–1. System Paths
primary or pri
Device
Your workstation’s default boot device
(usually the root disk)
Path Type
alternate or alt Your workstation’s alternate boot device
(usually a DDS-format tape device)
To display the current settings for the system paths, type the follow-
ing at the prompt:
Main Menu: Enter a command or a menu > path Enter
The paths are displayed in Mnemonic Style Notation, as shown in
Table D–2.
Resetting Your
Workstation
Displaying and
Setting Paths
The path command sets
and displays the hard-
ware address of a speci-
fied device attached to
the I/O bus of your
workstation.