EXFO FTB-500 - Manual (Page 440)

Communicating Through TCP/IP over Telnet
432 FTB-500
Internal Commands of the TCP/IP over Telnet Protocol
KILL LINS
Syntax: KILL LINS
You must specify the unit number and the slot number identifying the
module for which you want to terminate the session.
This command allows any user to terminate the session that contains the
specified connection (LINS). This means it will terminate all active
connections that belongs to a session.
To know the status of the modules before terminating connections using
the KILL LINS command, you can first enter the STATUS CLIENT
command. For more information, see STATUS CLIENT on page 433.
In the example below, two modules are connected: LINS13 and LINS10.
To disconnect the LINS10 module used by another session, enter the kill
lins10 command. The This client session is terminated message is
displayed once the module is disconnected.