EXFO FOT-930 Multifunction Loss Tester - Manual (Page 61)

Performing Automated IL/ORL/Length Measurements (F
AS T ES T )
Multifunction Loss Tester 53
Performing the F AS T ES T
For details about viewing F
AS
T
ES
T results, see Managing Test Results on page 55.
7. From the F
AS T ES T pane, set the next
cable/fiber names as needed (used
for automatic save).
8. Press the F
AS T ES T key or press Start
Test (F1/F2 key).
The units establish communication and automated tests begin. Measurements
appear on both units as they are taken.
9. Save the displayed values if you want.
If Auto save was activated for one or
both units, results are already saved.
9a. Change the displayed cable and
fiber names as needed.
9b. Press Store (F1/F2 key) to save
the values. The fiber name
increments automatically, ready
to save the next value.
If you are not satisfied with the results,
press F
AS T ES T and redo the test.
Unit A (Master) Unit B
Open lists to select cable/fiber
name for data to be saved.
Press Store to save results under
displayed name.
Press Next Tab to switch
to next result type.
Red/exclamation mark indicates
result that exceeds threshold.
Disk icon would indicate
unsaved results.
Press Setup to modify
F
AS T ES T parameters.
(FTTx view)