4 customizing your multifunction loss tester, Selecting the language of operation, 4customizing your multifunction loss tester – EXFO FOT-930 Multifunction Loss Tester User Manual
Page 25

Multifunction Loss Tester
17
4
Customizing Your
Multifunction Loss Tester
Selecting the Language of Operation
You may display the user interface in one of six languages (default is
English). If other languages become available in the future, you could
access them by replacing the unit software (see Upgrading the Embedded
Software on page 80). Values are kept in memory when you turn the unit
off. You may also
revert to factory settings
at any time.
To select a new interface language:
1. Press Menu, then select Setup > Unit.
2. Press Next Tab (F1/F2 key) until you get to
the Regional tab.
3. Use the arrows to select the Language list,
then press Enter to open it.
4. With the current language highlighted, use
the up/down arrows to select the desired language, then press Enter to
activate it.
To revert unit to factory-default settings:
1. Press Menu, then select Setup > Unit.
2. Press Factory Settings (F1/F2 key). Values on all tabs of the Unit Setup
pane are returned to factory settings.