beautypg.com

Adjusting the brightness and contrast – EXFO FOT-930 Multifunction Loss Tester User Manual

Page 27

background image

Customizing Your Multifunction Loss Tester

Multifunction Loss Tester

19

Adjusting the Brightness and Contrast

Adjusting the Brightness and Contrast

To fit your work environment, you may adjust the LCD brightness and
contrast. Values are kept in memory when you turn the unit off. You may
also

revert to factory settings

at any time.

Note: These settings do not apply to the

Fiber Inspection Probe

display. For

details, see Inspecting Fibers with the FIP on page 63.

To adjust the display brightness and contrast:
Press the

key repeatedly to switch between brightness levels (0-4-7-10).

OR

1. Press Menu, then select Setup > Unit.

2. Press Next Tab (F1/F2 key) until you get to

the LCD tab.

3. Use the up/down arrows to select the

Brightness or Contrast slider.

4. Use the left/right arrows to adjust the

brightness or contrast level.

To revert unit to factory-default settings:
1.
Press Menu, then select Setup > Unit.

2. Press Factory Settings (F1/F2 key). Values on all tabs of the Unit Setup

pane are returned to factory settings.