Eurocom R130T ELEMENT - Manual (Page 149)

Modules & Options
3.75G/HSPA Module 7 - 45
7
Before installing the application, make sure that the 3.75G/HSPA module is ON
(installing the driver with the module off will not allow the software to detect the
module hardware correctly). Use the Fn +
key combination (see Table 1 - 5, on
page 1 - 15 ) to toggle power to the 3.75G/HSPA module. When the 3.75G/HSPA
module is powered on, the indicator will briefly be displayed. Note that exiting
the application does NOT turn off the 3.75G/HSPA module.
• 3G Watcher - See “3G Watcher Application” on page 7 - 48 for driver installa-
tion information and “Setting Up a Carrier Profile” on page 7 - 49 for instruc-
tions on using the 3G Watcher application.
• HSPA Modem Interface - See “HSPA Modem Interface Installation” on
page 7 - 55 for driver installation information and “HSPA Modem Interface”
on page 7 - 56 for instructions on using the HSPA Modem Interface.
• Mobile Partner - See “Mobile Partner Application Installation” on page 7 -
64 for driver installation information and “Mobile Partner Application” on
page 7 - 65 for instructions on using the Mobile Partner application.
Important Notice
3.75G/HSPA & Blue-
tooth/Wireless LAN
Modules
In order to comply with
FCC regulations you
should NOT operate the
3.75G/HSPA module
and the Bluetooth/Wire-
less LAN modules at the
same time as this may
disrupt radio frequency,
and cause interference.
When the 3.75G/HSPA
module is powered on,
make sure that the Blue-
tooth/Wireless LAN
modules are powered
off.
3.75G/HSPA Modules & System Wake Up
Note that the 3.75G/HSPA modules DO NOT support system wake up on 3.75G/HSPA modem
activity.