Datalogic Scanning QUICKSCAN QS6500BT - Manual (Page 80)

Data Editing
5-6 QuickScan ® QS6500/QS6500 BT
Preamble/Postamble — continued
START
MODE BARCODE
Sets up to 22 characters each from the set of ASCII
characters or any hex value from 0 to FF. To config-
ure this feature, scan the “START” bar code above to
place the unit in Programming Mode, then the “SET
PREAMBLE” or “SET POSTAMBLE,” followed by the
digits from the Alphanumeric table in
Appendix B,
Alpha-Numeric Pad representing your desired
character(s). Reference the section, Example: Set-
ting a Postamble , for more information. Accept your
selection by scanning the “SET” bar code below,
scan the “TRANSMIT PREAMBLE” (or “TRANSMIT
POSTAMBLE” as applicable) bar code, then finally,
exit programming mode by scanning the “END” bar-
code below.
DEFAULT SETTING FOR THIS FEATURE: 00 (None)
Set Preamble
Disable
Preamble
Transmit
Preamble
Set Postamble
Disable
Postamble