Datalogic Scanning QUICKSCAN QS6500BT - Manual (Page 78)

Data Editing
5-4 QuickScan ® QS6500/QS6500 BT
Prefix/Suffix — continued
START
MODE BARCODE
Sets up to 22 characters each from the set of ASCII
characters or any hex value from 0 to FF. To config-
ure this feature, scan the “START” bar code above to
place the unit in Programming Mode, then the “Set
Prefix” or “Set Suffix,” followed by the digits from the
Alphanumeric table in
Appendix B, Alpha-Numeric
Pad representing your desired character(s). Refer-
ence the section, Example: Setting a Prefix , for
more information. Accept your selection by scanning
the “SET” bar code below and finally, exit program-
ming mode by scanning the “END” barcode below.
DEFAULT SETTING FOR THIS FEATURE: 00 (None)
Set Prefix
Set Suffix
SET
END