Aiwa CSD-EX110LH - Manual (Page 4)

PRECAUTIONS
Before connecting the AC cord (LH model only) * □
LH model has an AC VOLTAGE selector. Make sure that the AC
VOLTAGE selector Is set to the position matching your local voltage. If
it is not correctly set, change it with a screwdriver or a similar tool. Either
110-120V or 220-240V can be selected.
On placement
• Do not use the unit in places which are extremely hot, cold, dusty or
humid. In particular, do not keep the unit:
• in a high humidity area such as a bathroom
• near a heater
• in an area exposed to direct sunlight (e.g., inside a parked car,
please be careful because it may become extremely hot)
• Place the unit on a flat, even surface.
On safety
• When disconnecting the AC cord, grip the plug and not the cord itself.
Pulling the cord may damage It and thus be hazardous.
• When you are not going to use the unit for a long period of time,
disconnect the AC cord. If the cord Is plugged in a small amount of
current keeps on flowing to the unit even if the power switch is not on.
• If the AC cord is broken or damaged, or if the wires are exposed,
contact your dealer or an Aiwa service station and have it replaced or
repaired immediately.
On condensation
When the room is heated, you sometimes see water drops on your
windows. This is called condensation.
This can also occur inside the unit when:
• it is moved from a cold spot to a warm spot.
• It is used in a room where the heating system has just been turned on.
• it is used in a place with a lot of moisture.
• It Is used where it has direct contact with cool air, such as near an air­
conditioner.
When moisture has condensed inside, the unit may not function nor­
mally. Let It stand for 1 or 2 hours before turning the power on, or
gradually heat the room and dry the unit before use.
Should any trouble occur, disconnect the AC cord and refer servicing to
qualified personnel only.