Continuous play, 1 insert tapes into deck 1 and deck 2, 3 press the rev mode button to select z.') – Aiwa NSX-V9000 User Manual
Page 13: 4 press the -o- button to start playback
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CONTINUOUS PLAY
After playback on one deck finishes, the tape in the other deck
will start to play without interruption.
1
Insert tapes into deck 1 and deck 2.
2
Press the TAPE/DECK1/2 button to select the
deck to be played back first.
3
Press the REV MODE button to select
Z.').
4
Press the
-O-
button to start playback.
Playback continues until the ■ button is pressed.
/■
About cassette tapes
• To prevent accidental erasure, break off the plastic tabs
on the cassette tape after recording with a screwdriver or
other pointed tool.
Side A
Type II tape
detection
slot
-Tab for side A
To record on the tape again, cover the tab openings with
adhesive tape, etc. (On Type II tapes, take care not to
cover the Type II tape detection slot.)
' 120-minute or longer tapes are extremely thin and easily
deformed or damaged. They are not recommended.
' Take up any slack in the tape with a pencil or similar tool
before use. Slack tape may breaker jam in the mechanism.
DOLBY NR system
The Dolby Noise Reduction system reduces tape hiss noise.
For optimum performance when playing back a tape
recorded with the DOLBY NR system, turn on the DOLBY
NR system.
U
3
Q.
lU
ENGLISH
12