Bolens 132-395A - Manual (Page 4)

29. Never store the equipment with gasoline in
the tank inside a building where fumes may
reach an open flame or spark. Allow engine to
cool before storing in any enclosure.
30. To reduce fire hazard, keep engine free of
grass, leaves or excessive grease.
31. The vehicle and attachments should be
stopped and inspected for damage after strik­
ing a foreign object. The damage should be
repaired before restarting and operating the
equipment.
32. Do not change the engine governor settings
or overspeed the engine.
33. When using the vehicle with mower, proceed
as follows:
(1) Mow only in daylight or in good artificial
light.
(2) Never make a cutting height adjustment
while engine is running if operator must
dismount to do so.
(3) Shut the engine off and wait until the
blade comes to a complete stop before
removing the grass catcher.
(4) Check blade mounting bolts for proper
tightness at frequent intervals.
34. Check grass catcher bags frequently for wear
or deterioration. For safety protection, replace
only with new bag meeting original equipment
specifications.
35. Look behind to make sure the area is clear
before placing the transmission in reverse
and continue looking behind while backing
up.
ASSEMBLY
INSTRUCTIONS
B
H-
FIGURE 1.
NOTE
This unit is shipped WITHOUT GAS­
OLINE or OIL. After assembly, see
separate engine manual for proper
fuel and engine oil recommenda­
tions.
Tools Required:
(1) 7/16" Open End or Box Wrench
(1) 1/2" Open End or Box Wrench
(1) 3/4" Open End or Box Wrench
(1) Adjustable Wrench
-Contents of Hardware Pack:
(See Figure 1)
A (1) Steering Wheel Cap
B (1) Belleville Washer
C (1) Hex Lock Nut 5/16-18 Thread
D (1) Lock Washer V 2 " I.D.
E (1) Hex Nut 1/2-13 Thread
F (1) Cable Tie*
G (1) Battery Strap*
H (2) Ignition Keys
I (1) Battery Pack* (Not Shown)
J (4) Foam Strips” (Not Shown)
-Loose Parts in Carton:
(See Figure 2)
K (1) Battery Charger*
L (1) Charger Leads*
M Ò) Seat (Not Shown)
N (1) Steering Wheel (Not Shown)
* Electric Start Model 395 Only
FIGURE 2.