Bolens 111-518R000 User Manual
Owicipsgum, Rotary mowers, 9ы-07о-0œ) ¡¡mb
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
$
1.00
OWICIPSGUM
ASSEMBLY • OPERATION • MAINTENANCE • PARTS
21
"
ROTARY
MOWERS
Model Numbers
111-516R000
111-518R000
/9Ы-07О-0Œ)
¡¡Mb
1
%-ûlî-ÛQÙ ^QFT
Important; Read Safety Rules and Instructions Carefully
Made
^
in
AMERICA
WARNING: This unit is equipped with an internal combustion engine and should not be used
on or near any unimproved forest-covered, brush-covered or grass-covered land unless the
engine’s exhaust system is equipped with a spark arrester meeting applicable local or state
laws (if any). If a spark arrester is used, it should be maintained in effective working order
by the operator.
In the State of California the above is required by law (Section 4442 of the California Public
Resources Code). Other states may have similar laws. Federal laws apply on federal lands.
A spark arrester for the muffler is available through your nearest engine authorized service
dealer or contact the service department, P.O. Box 360900, Cleveland, Ohio 44136.
PRINTED IN U.S.A.
FORM NO. 770-7046F
Document Outline
- OWICIPSGUM
- ASSEMBLY • OPERATION • MAINTENANCE • PARTS
- 21"
- ROTARY
- MOWERS
- A
- A
- A
- Your lawn mower was buill to be operated according to the rules for safe operation in this manual. As DANGER: with any type of power equi pment, carelessness or error on the part of the operator can result In serious
- TRAINING
- PREPARATION
- OPERATION
- MAINTENANCE AND STORAGE
- CO
- o
- o
- CONTENTS OF HARDWARE PACK
- NOTE: Reference to right or ieft hand side of the mower is observed from the operating position.
- Tools Required for Assembiy
- UNPACKING
- ATTACHING THE LOWER HANDLE (Hardware A)
- ATTACHING THE UPPER HANDLE (Hardware B)
- AHACHING THE THRDHLE CDNTRDL (Hardware D)
- ATTACHING THE BRAKE CABLE
- SECURING THE CABLES (Hardware E)
- AHACHING THE STARTER ROPE (Hardware C)
- AHACHING THE REAR WHEELS (Hardware G)
- INSTALLATION OF HUB CAPS (Optional)
- FINAL ASSEMBLY OF MOWER
- ASSEMBLY OF GRASS CATCHER (Hardware F)
- ATTACHING BAG TO MOWER
- CONTROLS
- OPERATION
- ADJUSTMENTS
- LUBRICATION
- MAINTENANCE
- OFF-SEASON STORAGE
- HANDLE STORAGE
- Models 516R and 518R
- CONTENTS OF HARDWARE PACK