Ask Proxima Pro AV 9310L - Manual (Page 29)

c
USING THE PROJECTOR
'O T U m ON THE PROJECTOR
the projector to a source (Computer, VCR, Video Camera, Video Disc Player, etc.) using the appropriate
terminals on the side of the projector (See "CONNECTING THE PROJECTOR" section on pages 9-16).
Connect the projector's AC power cord into a wall outlet and turn the MAIN ON/OFF switch (located on the side of the
projector) to the ON position. The LAMP POWER indicator wilt light RED, the READY indicator will light GREEN,
Press the LAMP POWER ON/OFF button on the remote control unit or on the
projector to ON. The LAMP POWER indicator light wit! dim and the cooling fans will
operate. The wait display appears on the screen and the count-down starts
{30-29-28-...1), The signal from the source appears after 30 seconds.
i-
30 E
CAUTION:
THIS PROJECTOR USES A METAL-HALIDE ARC LAMP. TO EXTEND THE LIFE OF THE LAMP, ONCE
YOU HAVE TURNED IT ON, WAIT AT LEAST 5 MINUTES BEFORE TURNING IT OFF.
NOTE: TEMPERATURE WARNING INDICATOR flashes red, the projector will automatically turn off.
Wait at least 5 minutes before turning the projector on.
If the TEMPERATURE WARNING INDICATOR continues to flash, follow the procedures beiow:
(1) . Press LAMP POWER ON/OFF button to OFF.
(2) . Check the air fitter for dust accumulation.
(3) . Remove dust with vacuum cleaner (See "AIR FILTER CARE AND CLEANING” section on page 50.)
(4) . Press LAMP POWER ON/OFF button to ON.
'I If the TEMPERATURE WARNING INDICATOR still continues to flash, call your authorized dealer or service
station.
» TO TURN OFF THE PROJECTOR
Press the LAMP POWER ON/OFF button on the remote control unit or on the projector.
The "Power off ?” appears on the screen. Press again the LAMP POWER ON/OFF
button to turn OFF the projector. The LAMP POWER indicator will light bright and
READY indicator will turn off. The cooling fans wil! operate for 1 minute after the
projector is turned off. (During this "cooling down” period, the projector cannot be turned
on.) The READY indicator will iight green again and the projector may be turned on by
pressing ffie LAMP POWER ON/OFF button. To power down completely, turn the MAIN
ON/OFF switch (located on the side of the projector) to the OFF position.
DIRECT OPERATION
MODE SELECT
Press the MODE button (located on remote control unit or on the projector) to select
Computer 1, Computer 2, Video 1 or Video 2 Input. The "Computer 1”, "Computer 2“,
"Video r or "Video 2” display will appear on the screen for a few seconds.
Computer i v
Computer 2
Video ^ .
y y ® o 2
- 2 9 -