Ask Proxima Pro AV 9310L - Manual (Page 25)

REMOTE CONTROL BATTERY INSTALLATION
2 ^ Diiiie'ics‘i'!:o the
compc-rtriieni:.'
Note: For correct polarity (+
and - iermina!), be sure the
battery terminals are in
contact with the pins
In the
compartment
: n
/
The remote control unit can be used as wireless or wired remote control,
— - P - - I ■ • f — I - - , * , - F . - v , ' * - • - . - p * » i V - , r
.,U5JNp^THE REMOTE CONTROL UNIT (wireless);
Point the remote control toward the projector (Receiver window) whenever pressing the buttons. Maximum operating
range lor the remote control is about 16.4’ (5 m) and 60 ° front and rear of the projector.
USING THE REMOTE CONTROL UNIT (wired)j
Connect a remote control cable to R/C jacks located on the wireless/wired remote control unit and the side of
projector. the
A
To insure safe operation, please observe the following
precautions;
• Use (2) AA type alkaline batteries,
• Change two batteries at the same time.
• Do not use a new battery with a used battery.
• Avoid contact with water.
• Do not drop the remote control unit.
• If batteries have leaked on the remote control,
carefully wipe the case clean and load new batteries.
■ 2 5 -