Husqvarna 26H - Manual (Page 7)

0 4. DO NOT cut with dull,cracked or damaged metal blade.
5. Keep the unit and attachments in good working condition. Tighten fastening
parts at regular intervals. Check the cutting head assembly before each use.
Q 6. NEVER operate the unit without proper guards, shields or other safety
protective devices in place and properly connected.
Inspect to determine that these safety devices are installed properly, are in
good repair, and operate properly. If the condition or operation of these
devices is questionable, they must be repaired or replaced before using
the unit.
7. Make sure the cutting brades stops turning when the throttle
trigger is released and the engine runs at idle speed.
Q 8. DO NOT use any accessory or attachment other than those
supplied by the manufacturer for use with this particular unit.
9. Use only for jobs explained in this manual.
010. Inspect the entire unit before each use for worn, loose, or damaged parts.
DO NOT use until the unit is in proper working order.
E. Cautions during operation
1. Shut down immediately if the unit starts to shake or vibrate.
This could be a sign of danger from a broken part or missing fasteners.
2. Disconnect spark plug wire before you work on the unit or leave it unattended.
3. Hold the unit firmly with both hands.
4. After shutting down the engine, keep fingers and feet away
from the cutting blades until all rotation stops.
0 5. DO NOT put hands or feet near or under moving parts while engine is running.
6. Keep all parts of your body away from the muffler when the engine is running.
7. To avoid hitting small stones or other debris, do not cut too close to the ground.
8. Keep cutting attachment below waist level.
9. After striking a foreign object or if the unit vibrates abnormally, stop the engine,
disconnect and secure spark plug wire. Inspect the unit for any damage and
repair the damage.
F. Precautions after operation
0 1. DO NOT store the unit with fuel in the tank, because a fuel leak could start
a fire. Allow engine to cool before storing in any enclosure.
2. Before cleaning, repairing or inspecting, make certain cutting blades has
stopped. Disconnect and secure spark plug wire away from plug to prevent
accidental starting.
3. Cover the cutting blades when storing or during transport.
4. Use only recommended, genuine replacement parts to avoid creating
a hazard and/or voiding your warranty.
5. Store in a dry area out of the reach of children.
E-3