Ariens 929001 - Manual (Page 43)

FILLER AND OIL LEVEL PLUG ON]
b
Figure 47
IHYDROSTATIC DIFFERENTIAL
---------- -------------- ----------------------------------bX Tb
FILL FUEL TANK
Fill fuel tank with clean, fresh, regular grade gasoline. Do
not use premium gasoline.
ADJUST TIRE PRESSURE
Tires are over-inflated for shipping purposes. Correct tire
pressures are essential for proper handling or attachment
performance. Adjust tire pressures as shown in the chart. Use
a low pressure gauge for accurate readings.
DESCRIPTION LAWN SNOW THROWER AND
WORK FRONT BLADE WORK
Front tires (15 x 6.00-6) 10 12
¡Rear tires (20 x 8.00-10) 6 6
ASSEMBLE MOWER
1. Remove shipping straps from front support bar and belt
idler.
ATTACH MOWER TO THE TRACTOR
Use the following procedure to attach the mower to the
tractor:
1. Remove ignition key. Place implement power clutch lever
in the disengaged position and engage the tractor brake
lock.
CUTTING HEIGHT
ADJUSTMENT LEVER
IMPLEMENT POWER CLUTCH
2. Raise the tractor attachment lift lever.
3. Place cutting height adjustment lever in the second lowest
cutting position as shown in Figure 48.
4. Raise front support bar to clear the front tractor tire and
slide the mower under the tractor from the right side.
5. Place the drive belt over the rear lift point and lower the
attachment lift lever. Align ball joint of rear lift point to
tractor lift arms and secure with the "L" shape attaching
pin and hairpin cotter provided. See Figure 48.
6. Position drive belt over the drive and driven sheaves and
place idler to the inside of the belt as shown in Figure 48.
7. Position front support bar in the tractor saddle brackets
and secure with the locks and latches as shown in Figure 49.
A
FRONT SUPPORT
Figure 49
ADJUST BLADE LEVEL AND PITCH
IMPORTANT: ADJUST MOWER BLADE LEVEL
AND PITCH AS OUTLINED IN THE OWNER'S
MANUAL.
DELIVERY
u w, 'WFRONT support bar
I nwccT \ "L" SHAPED \\%^Xi
LUWti I attaching pin ^ tractor lift arms
CUTTING
POSITION AND HAIR PINv
COTTER Figure 48
Using the Owner's Manual as a guide, instruct the customer
as follows:
1. Instruct the customer on the operation of the tractor.
Emphasize safety and discuss the safety information in
the Owner's Manual.
2. Advise customer to change oil in the engine crankcase
after the first five hours of operation.
3. Advise customer to change the transmission oil filter after
the first five hours operation.
4. Explain how to perform the recommended lubrication
and periodic service.
5. Explain maintenance and adjustment instructions.
6. Demonstrate how to mount and dismount attachments.
7. Make certain the customer has his Owner's Manual.
8. Explain Ariens Warranty Policy. Fill out and return Ariens
Warranty Registration Card.
4 3