Ariens 929001 - Manual (Page 17)

HYDROSTATIC TRANSMISSION DRIVE BELT -
(Figure 36)
No adjustments are necessary when replacing the hydros­
tatic transmission drive belt. Belt tension is maintained by the
spring-loaded idler.
STORAGE
PREPARATION FOR STORAGE
1. Remove all oil, grease and dirt from engine and trans­
mission.
2. Clean the tractor exterior and tires thoroughly, removing
all mud, dirt and grease.
3. Touch up all unpainted and exposed areas with paint to
prevent rust.
4. Change engine oil.
5. Disconnect fuel line at fuel filter and drain fuel tank. Run
the engine until the fuel is exhausted from the system.
Clean the fuel filter.
6. Remove and clean battery. Check electrolyte level and
have battery fully charged. Store battery in a cool, dry
place where it will not freeze.
7. Remove the spark plug and pour one tablespoonful of
SAE 30 oil into the cylinder. Turn engine over manually
at least two revolutions.
8. Re-gap spark plug. Replace if required.
9. Check transmission and differential oil levels. Add oil as
required. Lubricate tractor thoroughly.
10. Store tractor in a cool, dry place to reduce tire deterio­
ration. Block up tractor to take the weight off the tires.
11. Inspect tractor for visible signs of wear, breakage or
damage. Order any parts required and make necessary
repairs to avoid delays when starting next season.
NOTE: Your authorized Ariens dealer ¡s trained and equipped
to service your tractor. A periodic check-up by your dealer
will help to reduce your maintenance costs.
PREPARATION FOR USE AFTER STORAGE
1. Replace battery and check electrolyte level.
2. Fill fuel tank with fresh, clean regular gasoline.
3. Check transmission, differential and engine oil levels.
4. Check tire inflation.
36 RM ROTARY MOWER
The Model 36 RM Rotary Mower is standard equipment
on both the S-8 Gear Shift and Hydrostatic tractors.
ATTACHING THE MOWER TO THE TRACTOR
Use the following procedure to attach the mower to the
tractor:
1. Remove ignition key. Place implement power clutch lever
in the "disengaged" position and "engage" the tractor
brake lock.
CUTTING HEIGHT
ADJUSTMENT LEVER
IMPLEMENT POWER CLUTCH
H
CUTTING
POSITIOI
AND HAIR PINv
FRONT SUPPORT BAR
^"LRACTOI
COTTER
2. Raise the tractor attachment lift lever. Figure 7.
LOWEST
CUTTING
POSITION
"L"SHAPED'
ATTACHING PINNYRA'CTOR LIFT ARMS
Figure 37
3. Place cutting height adjustment lever in the second lowest
cutting position, see Figure 37.
4. Raise front support bar to clear the front tractor tire and
slide the mower under the tractor from the right side.
5. Place the drive belt over the rear lift point and lower the
attachment lift lever. Align ball joint of rear lift point to
tractor lift arms and secure with the "L" shape attach­
ing pin and hairpin cotter provided. Figure 37.
Page 17