Ariens 924 - Manual (Page 47)

Auger/Impeller
If impeller brake shoe is not 1/16 to 1/8 inch from
belt, disengage clutch, loosen attachment idler nut,
reposition idler to compensate for belt length,
tighten nut and adjust attachment clutch per in­
structions below.
Adjust attachment clutch with both clutch lever and
clutch arm in disengaged position, pull clutch chain
taut and connect chain link to spring. Spring should
extend approximately 3/8" when clutch is engaged
but allow clutch arm (at lower end) to return to it's
maximum down position when clutch is disengaged.
7.5 Discharge Chute
7.6 Deflector
On ST 1136 remove one jam nut from deflector
cable, route cable through retainer mounted on
engine and chute bracket. Replace jam nut and
secure cable threaded connector (from left side) to
deflector bracket with cotter pin. Position deflector
in its lowest position with calDle control pushed full
in and tighten jam nuts on chute bracket.
NOTE: Check deflector movement to highest posi­
tion. Adjust jam nuts and/or threaded connector if
necessary to obtain full travel.
Slide handle end of Deflector Control Cable through
hole in upper handlebar panel and secure with
washer and jam nut. Secure T-Handle on end of
Deflector Control Cable.
A
DANGER: DO NOT put hands or feet near
or under rotating parts. Keep clear of dis­
charge opening at all times.
A
WARNING: NEVER direct discharge of
material toward bystanders nor allow any­
one in front of equipment while unit is in
operation. Be familiar with area of opera­
tion.
1. Discharge Chute
2. Mounting Clip
Figure 7-4: Discharge Chute
Remove mounting clips from discharge chute, oil
and position chute on auger/impeller housing.
Secure discharge chute with mounting clips and
hardware.
1. Discharge Chute
2. Deflector
3. Cotter Pin
4. Cable Control
5. Deflector Bracket
6. Mounting Clip
Figure 7-5: Deflector
NOTE: Chute must rotate freely.
7-5