Ariens 924 - Manual (Page 18)

Handlebars and Controls
Engine runs with interlock and/or traction clutch
engaged. Engine must stop if both are disengaged
with attachment clutch engaged.
Shorten interlock rod if engine will not run with
interlock, attachment clutch and/or traction clutch
engaged. Lengthen interlock rod if engine stays
running when both interlock and traction handle are
released with attachment clutch disengaged.
2.11 Electrical Interlock Adjustment Check switch bracket alignment with switch and
align if necessary.
To adjust length of rod, remove cotter pin from
upper interlock rod at handle, loosen lock nut and
turn rod to lengthen or shorten.
Figure 2-11: Electrical Interlock
2-10