Ariens 924 - Manual (Page 13)

Handlebars and Controls
1. Push Nut
2. Pin
3. Attachment Clutch Rod
4. Setscrew
5. Clevis
6. Cotter Pin
7. Chain
8. Spring
9. Rod Adapter
10. Traction Clutch Rod
11. Setscrew
12. Clevis
13. Push Nut
14. Pin
Figure 2-4: Attachment Clutch and Traction Rod
2.3 Clutch Handle
Remove (2) push nuts, pin and (2) screws holding
Clutch Handle and pivot to upper handle bar and
remove pivot and disconnect Clutch Handle from
clutch rod.
Remove set screw, jam nut and clevis from clutch
rod.
Remove cotter pin connecting rod to chain and
remove rod.
Disconnect chain and clutch spring from lever.
Check parts for wear or replacement.
Assemble, using reverse procedure.
2.4 Attachment Clutch Adjustment
Attachment Clutch is adjusted by connecting chain
to spring just below attachment clutch rod. Connect
spring to a chain link so chain is snug but so attach­
ment idler drops away from belt with lever all the
way up.
2.5 Wheel Drive Clutch Lever and Traction Rod
Remove (2) push nuts, pin and (2) screws holding
pivot and Wheel Drive Clutch Lever to upper handle
bar and remove pivot and Wheel Drive Clutch Lever.
Remove set screw, nut, hair pin and clevis pin
holding clevis to Traction Clutch Rod.
Remove set screw in rod adapter and remove Trac­
tion Clutch Rod.
Check parts for wear or replacement.
Assemble, using reverse procedure.
2-5