Viconics VZ7260X Installation Guide - Manual (Page 15)

15 | VZ7260B Series - Installation Guide
Local keypad interface
When left unattended for 45 seconds, the display will resume automatic status
display scrolling.
To turn on the back light, press any key on the front panel. The back lit display will
turn off automatically after 45 seconds.
I
NSTALLER
C
ONFIGURATION
P
ARAMETER
M
ENU
Configuration can be done through the network or locally at the Terminal Equipment
Controller.
 To enter configuration, press and hold the middle button (°C/°F or Override) for
8 seconds.
• If a password lockout is active, “Password” is prompted. Enter password value
using the “up” and “down” arrows and press the middle button again to gain
access to all configuration properties of the Terminal Equipment Controller.
Entering a wrong password will prevent local access to the configuration menu.
 Press the same middle button repetitively to scroll between all the available
parameters.
 Use the up and down key to change the parameter to the desired value.
 To acknowledge and save the new value, press the middle button again.
 The next parameter will now be displayed.
 An Override can be made during an unoccupied period. If the Override
option is enabled in the lockout configuration pressing the override key
will resume occupied setpoints for a time specified by parameter
ToccTime
 In cooling mode only the cooling setpoint is displayed,
 In heating mode only the heating setpoint is displayed
 In auto mode, (See below)
 In cooling mode only the cooling setpoint is displayed,
 In heating mode only the heating setpoint is displayed
 In auto mode, (See below)