beautypg.com

Viconics VT7606E Installation Manual User Manual

Page 3

background image

3

| PIR Ready VT7600 Series-Installation Guide

028-0363-02

• If replacing an existing Terminal Equipment Controller, label the wires

before removal of the Terminal Equipment Controller.

• Electronic controls are static sensitive devices. Discharge yourself

properly before manipulating and installing the Terminal Equipment

Controller.

• A short circuit or wrong wiring may permanently damage the Terminal

Equipment Controller or the equipment.

• All VT7000 series Terminal Equipment Controllers are designed for

use as operating controls only and are not safety devices. These

instruments have undergone rigorous tests and verification prior to

shipping to ensure proper and reliable operation in the field. Whenever

a control failure could lead to personal injury and/or loss of property,

it becomes the responsibility of the user / installer / electrical system

designer to incorporate safety devices (such as relays, flow switch,

thermal protections, etc…) and/or an alarm system to protect the entire

system against such catastrophic failures. Tampering with the devices or

unintended application of the devices will result in a void of warranty.

10. Insert each wire according to wiring diagram.
11. Gently push excess wiring back into hole (Fig. 3).
12. Re-Install wiring terminals in their correct locations (Fig. 3).
13. Re-install the cover (top side first) and gently push extra wire length back into the

hole in the wall.

14. Install security screw.