Tuffy Security 142 - Manual (Page 3)

Page 3 of 6 - 3/6/2009 – Rev030609
14. Insert the #8 Windshield mounting bracket over the center loop catch as illustrated then refasten both #7.5 loops with the original
hardware #7.16. (See Figure 4)
15. Re-install the #7.21 cover by tucking the ends in then aligning the inserts and pressing firmly to pop it securely in. (See Figure 4)
16. Remove the #7.6 factory sound bar by removing the 6 mounting screws and unplugging the wiring harness. Save all this
hardware it will all be reinstalled. (See figure 5)
NOTE: Having the necessary parts and hardware within reach before starting the following steps will make the installation
process easier.
17. Place the Tuffy Overhead Console as illustrated and fasten the holes on the front of #12 Top Panel to the corresponding holes in
the #8 Windshield Mounting Bracket and with the Tuffy Overhead console as far forward as possible fasten it using the provided
hardware #7.13, 7.15, and #7.14. Make sure the rear of #12 top panel is resting on top of the sport cage #7.4. (See Figure 5)
18. With the Tuffy Overhead Console centered fasten the rear of #12 Top Panel to the sport cage bar #7.4 using the #4 Clamp bracket
around the bottom and fastening it with the illustrated hardware #7.1, #7.2 and #7.3. (See Figure 5)
19. Connect the Electronics equipment in the Tuffy Overhead console and check the operation. Follow the manufacturer’s
directions for connecting the supply wires to your electronic equipment. (See Figure 5)
20. Reinstall the original #7.6 sound bar using the (6) original screws. Don’t forget to plug the wiring harness back in. (See Figure 5)
21. Reinstall the front tops. To access the clamps for the top installation and removal by loosen #9.13 knob screw and sliding the
electronics assembly toward the back to expose the #7.18 top front lever. (This #7.18 lever is in an alternate location on early
JK’s) Once all the exposed top levers have been undone, if there is still a difficult to reach lever still engaged behind the Tuffy
Overhead console, both tops can be lifted up together and shifted to the side to expose any other hard to reach lever. (See Figure
6)
22. Be sure to keep the #9.13 Knob screw tight at all times and do not operate the vehicle with the electronics assembly not slid all
the way forward. (See Figure 6)