Tuffy Security 173 - Manual (Page 7)

Page 7 of 8 – 12/20/06 – Rev 11/4/13
Figure 7
21. Install the lid #3 by placing it on the enclosure assembly so the welded studs with bolts #10.12 are overlapping the
enclosure toward the front of the vehicle. The end of the lid #3 with the Tuffy logo should face the rear of the vehicle.
Then pull the lid assembly toward the rear of the vehicle till it stops while guiding the welded studs into the slots on the
side panels #8 and #9. (See Figure 8)
Figure 8
22. Close the lid #3. The welded studs on the lid #3 with bolts #10.12 located toward the rear of the vehicle should now
overlap the end of the side panels. Push the lid toward the front of the vehicle till it stops while guiding the welded
studs into the slots on the side panels #8 and #9. When the rear vehicle door is shut it prevents the lid from being
pulled toward the rear releasing it from the slots. When the rear vehicle door is locked so is the Tuffy enclosure. (See
Figure 9)