Canon CDI-E075-010 - Manual (Page 75)

69
Shooting - Letting the Camera Select Settings
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
In macro mode, the correct image brightness sometimes cannot be obtained with
flash photography. Please set the ND filter to [On] and use the separately sold Macro
Ring Lite MR-14EX or the Macro Twin Lite MT-24EX for flash photography in the
macro mode. Use the
or mode and set the aperture to a higher value as
required by the shooting conditions.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
• Some settings are not available with certain Shooting modes. Please refer to
Functions Available in Each Shooting Mode (p. 208).
• Always use the LCD monitor to compose images in macro mode. Shooting with
the viewfinder is possible, though, the parallax phenomenon may cause images
composed with the optical viewfinder to be off-center.
• When the lens is zoomed to the wide angle end, the recordable area is
approximately 75 x 55 mm (3.0 x 2.2 in.) at the closest focal distance, and at
telephoto end, it is approximately 56 x 42 mm (2.2 x 1.7 in.), roughly the size
of a business card. If optional Close-up Lens 250D 58mm (p. 184) is used in
macro mode, the recordable area is approximately 37 x 28 mm (1.5 x 1.1 in.) at
maximum telephoto.
Macro Mode
Use the macro mode to shoot close-ups of subjects in the range of 5 to 50 cm
(0.16 to 1.6 ft.) at wide angle end and 15 to 50 cm (0.49 to 1.6 ft.) at telephoto
end.
1 Press the button to turn the LCD monitor on.
2 Press the button.
• The icon appears on the display panel and on
the LCD monitor.
• Press the button again to cancel the macro
mode.
3 Shoot the image.
• The indicator beside the viewfinder will light yellow when the shutter button
is pressed halfway.
• Shooting procedures are the same as for the Mode (p. 51).