TeeJet CenterLine 230BP - Manual (Page 20)

CenterLine 230BP
020-034-UK R3
19
Establish
Point A
Establish
Point B
+0
6.0 MPH
+0
6.0 MPH
+0
6.0 MPH
0.0
Navigation
Screen
A
B
Curved A-B Guidance
Curved A-B Guidance is similar to Straight A-B Guid-
ance except that the reference line is curved.
NOTE: Curved Guidance is recommended not to
exceed 30 0 within the A-B guideline.
NOTE: Steps 1 - 3 are only applicable if a Smart-
Cable or SDM are installed on the sys-
tem.
1. Turn the controller master switch to the “On”
position. The individual boom section switches
should remain in the “Off” position.
2. To activate automatic boom section control,
press the Swath Status Switch key until Auto
Mode is illuminated on the console.
3. In areas where application is not desired, manu-
ally turn “Off” the rate controller master switch to
shut off the booms. Turn the master switch “On”
to resume application.
4. Use the Guidance Mode key to select Curved
A-B guidance.
5. Drive to the desired location of Point A. While the
vehicle is in motion, press the Mark A/B
key
to establish Point A. Point B will be displayed on
the screen. Drive to the location of Point B and
press the Mark A/B
key again to establish the
ALL ON
AUTO
MAN
ALL ON
AUTO
MAN
KM/H KM/H
1. Turn the controller master switch to the “On”
position. The individual boom section switches
should remain in the “Off” position.
2. To activate automatic boom section control,
press the Swath Status Switch key until Auto
Mode is illuminated on the console.
3. In areas where application is not desired, manu-
ally turn “Off” the rate controller master switch to
shut off the booms. Turn the master switch “On”
to resume application.
4. Use the Guidance Mode key to select Straight
A-B guidance.
5. Drive to the desired location of Point A. While the
vehicle is in motion, press the Mark A/B key
to establish Point A. Point B will be displayed on
the screen. Drive to the location of Point B and
press the Mark A/B
key again to establish the
A-B line. The CL230BP will immediately begin
providing navigation information with the light-
bar and Navigation Screen.
6. Use the Change Page key to advance the
screen views.
KM/H