TeeJet CenterLine 230BP - Manual (Page 14)

CenterLine 230BP
020-034-UK R3
13
FINAL TILT CALIBRATION SCREEN
The Final Tilt Calibration Screen will
be displayed. This will show that Tilt
Calibration has been completed. Af-
ter 5 seconds the screen will time out
and return to the Operation screen.
Display Setup Mode
Press the Setup Mode key until the initial Display
Setup Mode screen appears.
DISPLAY SETUP SCREEN
This is the initial Display Setup Screen.
Setup screens will time out after 10
seconds of inactivity (changes will be
saved). After time out, the screen will
go back to Operation Mode. Pressing
the Escape
key will also exit the
user from Setup Mode without saving
any changes. Press the Enter
key
to advance to the Display Brightness
setting.
DISPLAY BRIGHTNESS
The Plus and Minus keys can
be used to change the brightness lev-
els of the display screen. Press the
keys until the desired brightness is
established. Press the Enter
key
to advance to the Display Contrast
setting.
Check/Uncheck the box by using the
Plus
or Minus keys. The Plus
key selects (checks) the box. The
Minus key deselects (unchecks)
the box. Press the Enter key to
accept the changes and advance to
the Antenna Height setting.
ANTENNA HEIGHT
Measure the height of the antenna
from the ground. Enter the antenna
height (in meters with one decimal)
on the antenna height page using the
Plus
and Minus keys. Press the
Enter key to accept the changes
and advance to the Level One set-
ting.
LEVEL ONE
Position the vehicle on a level sur-
face. Press the Enter
key to ad-
vance to the next Level screen.
LEVEL TWO
Turn the vehicle 180 degrees and
reposition the vehicle at the same
location. Press the Enter
key to
record the level position.
4
5
12.5
2
3