TeeJet IC18 SPREADER JOB COMPUTER - Manual (Page 7)

3
98-05271 R0 UK
OVER
VIE
W
SE
TUP
APPENDIX
GE
TTING ST
AR
TED
OPER
ATION
ISOBUS Job Computer : IC18 Spreader European
CHAPTER 2 – GETTING STARTED
• A firm touch is required when selecting a screen icon.
• Settings are NOT automatically saved when selected. The ACCEPT KEY must be selected to save the setting. Select the
ESCAPE KEY to escape without saving settings and return to the previous menu.
• The console needs to be cycled off and back on when changing or attaching equipment to the system.
• The menu structure on your display might vary from the one displayed in this User Manual depending on the virtual terminal being
used.
START UP
Power is continuously supplied to the job computer. The virtual terminal will give access to the job computer options and operation.
Figure 2-1: Master Screen
Matrix VT Setup Key
IC18 Spreader
Master Screen Key
Other options as available on
ISOBUS system
CALCULATION MODE
The IC18 job computer is programed to calculate calibrations based on European or North American methods.
◄European – Gate Height is NOT calculated into the product application and calibrations will be based on volume per pulse.
◄North America – Gate Height is calculated into the product application and calibrations will be based on pulses per volume.
This setting has been established before leaving the factory, but it can be changed after purchase with assistance from TeeJet
Technologies Customer Service or your local dealer through the OEM setup menu options.
Figure 2-2: European
Figure 2-3: North America
This manual discusses
specifically the functions
and options in European
Mode. See the specific
IC18 Spreader: North
America User Manual for
functions and options in
North America Mode.