Carrier 50PEC09-18 - Manual (Page 23)

23
Fig. 22 — 50PEC Unit Remote-Mounted Thermostat with Deluxe D Controller Wiring
Deluxe D
Deluxe D
AL — Alarm Relay Contacts
BR — Blower Relay
CAP — Capacitor
CB — Circuit Breaker
CO — Sensor, Condensate Overflow
CR — Compressor Relay
DM — Damper Motor
FP1 — Sensor, Water Coil Freeze Protection
FP2 — Sensor, Air Coil Freeze Protection
FSS — Fan Speed Switch
HP — High-Pressure Switch
JW4 — Jumper Wire for Alarm
LOC — Loss of Charge Pressure Switch
NLL — Night Low Limit
PB — Power Terminal Block
RVS — Reversing Valve Solenoid
TRANS — Transformer
WV — Water Valve
---------- Field Line Voltage Wiring
Field Low-Voltage Wiring
Printed Circuit Trace
Option Low Voltage Wiring
Relay/Contactor Coil
Solenoid Coil
Thermistor
Circuit Breaker
Relay Contacts-N.O.
Switch-High Pressure
Switch-Low Pressure
Ground
Wire Nut
Mate-N-Lock
>>
*Optional wiring.
NOTES:
1. Compressor and blower motor thermally protected
internally.
2. All wiring to the unit must comply with local codes.
3. Transformer is wired to 240-V (ORG) lead for 240-
1-50 units. For 220-1-50 operation, switch the RED
and ORG leads at L1 and insulate the RED lead.
Transformer is energy limiting or may have a circuit
breaker.
4. FP1 thermistor provides freeze protection for
water. When using anti-freeze solutions, cut JW3
jumper.
5. Low voltage wiring must be class 1 and voltage
rated equal or greater than unit supply voltage.
6. Factory cut jumper (JW4). Dry contact will be avail-
able between AL1 and AL2.
7. Transformer secondary ground via GRN/YEL wire
from C to control box.
8. See view A for wiring of units with water valve (part
no. 23B00112N01) or view B for units with water
valve (part no. 23B00112N03).
LEGEND