SilentKnight 5129 Digital Alarm Communicator Transmitter - Manual (Page 26)

Model 5128/29 Fire Slave Communicator Installation Manual
22 150805
5.2.1 Special Characters for Dialing
Use Table 5-1 to determine which special characters to use when setting the Line Prefix options during
programming.
5.3 Programming with the 5541 Downloading Software
The Model 5541 Remote Downloading Software can be used to program the 5128/29 from a remote site. Note
that Revision 3.7 or later of the software is required. The Model 5530 Modem must also be connected to the
computer that runs the software.
The downloading software is organized into menus. As you move through the software menus, the screens tell
you how to select options. The programming form in Section 5.4 lists the options by step number, that is, in the
order they appear if you use the 5230 to program. The form also tells you which 5541 software menu the
option appears on. (See Figure 5-1 for an example.)
Refer to the manuals that accompany the downloading software and modem for information about how to set
up and run the software and modem.
5.4 Programming Options
This section of the manual describes the programming options. Figure 5-1 shows how you can use the pro-
gramming form, which begins on the next page, to keep a record of how you have programmed an installation
by checking off or writing in your choices in Column 4 of the chart. The factory-programmed defaults also
appear in Column 4. This form is perforated for your convenience.
Figure 5-1 Using the Programming Form
Table 5-1: Special Characters
To Enter: Press LCD Display
Pause A
* B
# C
2nd Dial Tone D
1
2
3
4