SilentKnight 5129 Digital Alarm Communicator Transmitter - Manual (Page 25)

Programming
150805 21
5.2 Programming with the 5230 Remote Annunciator
Note: The system will automatically time out of programming mode if no keys are pressed for four minutes. If you press
function keys very quickly, you may get ahead of the LCD display. Wait for the appropriate message to be dis-
played before you press
.
TO: KEYSTROKES:
ENTER PROGRAMMING MODE [Installer’s Code]
The first line of the LCD will show the programming option for
Step 1, “ZONE ACTIVE.” The second line will show the most recently programmed
value for that option.
PROGRAM AN OPTION Type in your new data and then press .
SKIP A STEP Press .
The data in the skipped step will not change. The LCD will show the next option.
GO TO A SPECIFIC STEP Press . The first line of the LCD will show “ENTER THE STEP #” and the
current step number. Type in the new step number, then press . Line 1 of
the LCD will show the option name; line 2 will show the programmed data for the
step. (If you try to go to a step that does not exist, the display will go back to the
previous step.)
SELECT YES OR NO Press any digit to toggle Yes and No.
SELECT AN OPTION FROM A MENU Press the option number. (Option numbers appear next to the option name in Section
5.3.)
ENTER ALPHABETIC DATA OR
NUMBERS LARGER THAN 9 for A or 10
for B or 11
for C or 12
for D or 13
for E or 14
Note that only the alphabetic characters appear on the display.
CORRECT AN ERROR
(If you have not pressed the
key.)
Press . Then type in the correct data and press .
LEAVE PROGRAMMING MODE
AT ANY TIME Press .
ENTER
2 7 ENTER
ENTER
ENTER
STEP
ENTER
SHIFT 1
SHIFT 2
SHIFT 3
SHIFT 4
SHIFT 5
ENTER
CLEAR ENTER
STEP STEP CLEAR CLEAR