Receiving your incubator, Inspecting the shipment, Nspecting the – Shellab SCO6AD User Manual
Page 7: Hipment
7 |
P a g e
RECEIVING YOUR INCUBATOR
Before leaving the factory, SCO6ADs are packaged in high-quality shipping materials to provide
protection from transportation-related damage.
When an incubator leaves our factory, safe delivery becomes the responsibility of the carrier.
Damage sustained during transit is not covered by the manufacturing defect warranty. When you
receive your SCO6ADs inspect it for concealed loss or damage to the interior and exterior. If
you find damage,
follow the carrier’s procedure for claiming damage or loss.
I
NSPECTING THE
S
HIPMENT
Carefully inspect the shipping carton for damage. Report any damage to the carrier service that
delivered the incubator. If the carton is not damaged, open the carton and remove the contents.
Carefully check all packaging before discarding. Save the shipping carton until you are certain that
the unit and its accessories function properly.
The unit should come with an Installation and Operation Manual, warranty card and a Certificate of
Compliance. Verify that the correct number of shelves, shelf slides, leveling feet, and other
components have been included (see the table below for quantities).
Note: The SCO6AD requires a CO
2
gas regulator. A regulator is not included with the SCO6AD.
section on page 46 if you wish to order one from Shel Lab.
Included Accessories
1 Anti-Microbial
Copper Token
4 Leveling Feet
1 Power Cord
1 Stainless Steel
Humidity Pan
3 Stainless Steel
Shelves
6 Stainless Steel
Shelf Slides
4 Stainless Steel
Shelf Standards
1 Tubing Kit