Shellab SCO6AD - Manual (Page 39)

39 | P a g e
USER MAINTENANCE
Warning : Prior to any maintenance or cleaning of this unit, disconnect the power cord from the power
supply.
Avertissement : Avant d'effectuer toute maintenance ou entretien de cet appareil, débrancher le
cordon secteur de la source d'alimentation.
C
LEANING AND
D
ISINFECTING
If a hazardous material or substance has spilled in the incubator, immediately initiate your site’s
Hazardous Material Spill Containment protocol. Contact your local Site Safety Officer and follow
instructions per the site policy and procedures.
The incubator chamber should be cleaned and disinfected prior to first use. Periodic cleaning and
disinfection are required to prevent microbiological contamination.
Do not use spray on cleaners or disinfectants. These can leak through openings and coat electrical
components. Do not use cleaners or disinfectants that contain solvents capable of harming paint
coatings or stainless steel surfaces. Do not use chlorine-based bleaches or abrasives; these
will damage the chamber liner.
Warning : Never clean the unit with alcohol or flammable cleaners.
Avertissement: Ne jamais nettoyer l'appareil à l'alcool ou avec des nettoyants inflammables.
Cleaning
Remove all non-attached chamber components and accessories (shelves, racks, and any
additional items), if present.
Clean the chamber interior with a mild soap and water solution, including all corners.
Take special care when cleaning chamber temperature probes heads located at the rear of
the chamber on the left side.
Clean all removable accessories and components. The humidity pan should be cleaned
frequently.
Clean and disinfect any attached sample tubing and replace if discoloring is present.
Rinse the chamber surfaces and shelving with distilled water and wipe dry with a soft cloth.
Do not use deionized water. See the Distilled and Deionized Water paragraph in the
Installation section.